Polo II: Twist & Lock IP65 Bulkhead with Integrated LED Tray

CCT Switching

The CCT switch is located on the front of the gear tray, on the same side as the LEDs, with 4 different options, 3000K, 3500K, 4000K and 5000K.

Wattage Switching

It has 3 different switchable wattages, 9W, 12W and 15W, and the switch is located inside the fitting on the driver.

Plug-in Sensor & Emergency

The plug-in sensor & emergency module can be easily secured to the fitting with the twist and lock clips on the base. Also, the sensor is configurable with the Universal Remote Control.

1. Place the emergency module into the slot on the back of the LED tray – make sure you have connected the battery inside the EME first.

2. Then, turn the twist and lock clips to secure the emergency module in place.

3. Connect the blue wire to the Neutral (N) and the brown wire to the Unswitched Live (L1) of the push-wire connector.

4. Connect the output of the emergency module to the driver on the back of the gear tray using the cable provided.

1. Snap and remove the rectangle covering piece on the LED gear tray.

2. Insert the sensor into the back of the LED tray and ensure the front of the sensor is visible through the rectangular window.

3. Connect the sensor to the driver using the 4-pin to 3-pin cable provided.

Hinged, Easy Release Tray

A brand new addition to the Polo II – the LED tray is hinged to the base of the bulkhead for ease of installation and maintenance.

BESA Box & 20mm Conduit Entry

The BESA Box fitting point is located on the bottom in the middle of the fitting and there are an additional four 20mm Conduit entry points around the outside of the fitting.

Twist & Lock Diffuser

The IP65 diffuser can easily be installed thanks to its twist & lock design – for quick installation and maintenance.

There is a variety of clip-on rings available to customise your bulkhead, choose either a standard ring or and eyelid one in either black or white finishing.

The Polo II has an upgraded energy efficiency of up to 140lm/W.